12-Strand Single Braid Eye Splice (Brummell)
Machovec is proud to bring you these
rope splicing instructions. Eye splicing a rope is one of the most asked
for procedures. Having a permanently fixed loop (eye splice) on a rope end
removes the need to tie and then untie a knot each time you wish to use
it. Rope splicing is a very strong method of fixing a loop eye; as the
rope is pulled tighter so the spliced strands become more and more
squeezed and locked into place. Rope splicing removes the worry of a knot
becoming undone and a spliced eye is less bulky. You can buy 3-strand,
8-strand or 12-strand rope with an eye already spliced in or you you can
make your own by following these instructions for eye splicing a rope.
Mark rope in one full fid length from the bitter end.
This is mark "A". Measure one long fid section further. This is mark "B".
Form the desired eye size and place mark opposite "B". This is mark "C".
Continue down the rope an additional 1-1/2 fid lengths. This is mark "D".
Work from mark "A" toward the bitter end. Mark the sixth pic and
continue marking every 5 pics. Cut and remove these strands back to bitter
end and re-tape the bitter end.
To mark the tuck points in the area in between points "B" & "C", mark
the 3rd, 6th, and 9th pics. Open up "B" with a fid tool and pass the
bitter end and tail through the rope completely. Pull the tail through
until "A" & "B" align. Make subsequent tucks in the same manner between
the 3rd and 4th, 6th and 7th strands. (Figure 2)
Pull the tucks tight as you go. After the last tuck
above, attach your splicing tool to the tail and insert it between the 9th
and 10th strand, exiting the rope at mark "D". Remove the tool and the
tape wrap from the tail end. Hold the eye firmly and smooth the rope down
the standing part. The tail will withdraw into the rope.
We hope you found these rope splicing
instructions helpful. If you require any further assistance, feel free to
call Jay @ 612-282-4035.